What should I do if the jaw crusher is too noisy during construction?

Many construction sites are equipped with jaw crushers, but the jaw crusher is too noisy during construction, which will cause serious noise pollution and affect people's physical and mental health. So how to reduce the noise? Here are a few ways:

What should I do if the jaw crusher is too noisy during construction?

1. Adjust the spring preload pressure

Sometimes the jaw crusher will cause abnormal noise due to the inertial force generated by insufficient spring preload pressure. Users can reduce the noise of the equipment by adjusting the compression force of the spring, but the pressure of the spring must also be paid attention to. It should not be too loose or too tight. It must be controlled well.

2. Ensure the normal operation of the flywheel

When the V-belt is not tight enough, it may cause the flywheel to rotate abnormally and deviate from the machine position. At this time, it will cause the jaw crusher to make noise, so it is necessary to ensure that the V-belt has a suitable tightness. If the flywheel is not in the right position, the flywheel needs to be removed and repositioned.

3. Strictly control the feeding

Control the feeding of the jaw crusher, prohibit the particle size or water content of the material from exceeding the feeding requirements of the jaw crusher, and prohibit impurities from entering the equipment when the operator is operating the jaw crusher. This can effectively prevent the equipment from making abnormal noise during operation and extend the service life of the jaw crusher.

4. Timely tightening of parts

Since the jaw crusher will produce a large impact during operation, it may cause the internal parts of the equipment to fall off or loosen. It is necessary to regularly check the tightening of the internal parts of the equipment and tighten the nuts and bolts of the equipment in time.

5. Do a good job of lubrication

The last point is to do a good job of lubrication of the jaw crusher. Poor lubrication will cause the jaw crusher to run uncoordinated, thereby generating abnormal noise. Therefore, the jaw crusher should be cleaned regularly and lubricated and maintained well, so as to ensure the coordination and efficient operation of the equipment parts and reduce the generation of noise.

The above is the solution to the problem of too much noise of jaw crusher. It can be dealt with according to the actual situation of the equipment, so as to reduce the maintenance cost of the equipment and improve production efficiency. If you want to know the basic information of other equipment, you can call or contact CFTC online customer service staff, and we will give you a satisfactory answer to your questions.